Clarke CBS12WV Specifikace

1000305mm (12”) Portable BandsawModel CBS12WVPart Number 6460030OPERATING & MAINTENANCEINSTRUCTIONS©

10(d) Blade Guide Adjustments (Ref: fig 5)NOTE: These adjustment are carried out at the factory. It is not therefore necessary to checkor make readjus

11OPERATIONWARNING! Make sure the bandsaw is correctly assembled and adjusted before use. Read and follow all safety instructions (see page 3)• The

12IMPORTANT: Before plugging in to the mains supply, the blade guard MUST be adjusted sothat a minimum amount of blade is visible when cutting takes p

13Replacing the Saw Blade: (Ref: Fig.4)The saw blade is not easy to sharpen, and we recommend fitting a replacement when theblade becomes blunt, loses

2 Wheel HT146002033 Hex Nut HT2701003127 Mitre Shaft HT260100811211 Knob Screw HT1460110112 Switch Box HT1460120113 Machine Screw HT265101111215 Switc

15Spare Parts Diagram

2© Copyright Clarke International. October, 2000. All rights reserved

SpecificationsModel No. ... CBS12WVPart No. ...

Thank you for purchasing this Clarke 12 inch Bandsaw. This machine is designed to rip andcross cut wood exclusively and for DIY, and hobby use ONLY.

Electrical ConnectionsWARNING! THIS APPLIANCE MUST BE EARTHEDIMPORTANT: The wires in the mains lead are coloured in accordance with the followingcode:

(1) Attach the Feet (Ref: fig 1)1. Unscrew the fours securing knobs (2) and remove the front cover. (see WARNING above)2. Attach the feet (12) to the

Fig. (2) Cover RemovedFig. (3) Rear View7 13 Foot Securing screw (x4) 14 Control Panel (On/Off/Speed) 15 Microswitch 18 Table Securing Knobs (x2) 19

(3) Attach the Bandsaw to a WorkbenchFix the bandsaw to a suitable Workbench using screws or bolts (not supplied), through theholes in the feet with w

26 24 23 2591. Remove the table by fully unscrewing the two securing knobs, then slacken off all upperand lower blade guides as described under ‘Blad