Clarke CAT47 Specifikace Strana 1

OPERATING & MAINTENANCEINSTRUCTIONSGC0414 1” IMPACT WRENCHModel No: CAT47Model No: 3110640

10STORAGE1. Store the tool safely in its box in a dry, secure environment.2. If the tool is not to be used for longer than 24 hours, run a few drops o

11PARTS LISToN noitpircseD oNtraP oN noitpircseD oNtraP1gnisuoHrotoM042011100828B72revoCtsuD000077760828B2paCdnE042011430828B82eveelSevlaV001026200828

12PARTS DIAGRAMA wide range of airline accessories is available from your nearest Clarkedealer, for further information, contact your nearest dealer,

13VIBRATION EMISSIONSMODEL No: CAT47DESCRIPTION: IMPACT WRENCHDeclared vibration emission value in accordancewith EN12096Measured vibration emission v

14You will note that a third value is given in the specification - the highestmeasured reading in a single plane. This is the maximum level of vibrati

15DECLARATION OF CONFORMITY

2INTRODUCTIONThank you for purchasing this CLARKE Impact Wrench.Before attempting to operate the machine, it is essential that you read thismanual tho

3SAFETY PRECAUTIONSWORK ENVIRONMENT1. Keep the work area clean and tidy.2. Dress appropriately - do not wear loose clothing or jewellery. Tie long hai

412. Never force or misuse the tool. It will do a better and safer job at the ratefor which it was designed.12. Never use this product if it is defect

5INTRODUCTIONThe CAT47 is a professional, 2-hammer, 1” square drive impact wrench with anextended anvil.1. 1” Square Socket Drive2. Side handle3. Forw

6• A pressure of 90 psi with a flow of 7.44 cfm is required. Too high an airpressure will shorten the life of the tool due to excessive wear.A typical

7OPERATIONCAUTION: ALWAYS BE SURE THAT THE TOOL IS OFF BEFORE ATTACHINGOR REMOVING A SOCKET. ALWAYS TAKE CARE TO USE THE CORRECTSIZE SOCKET FOR BOLTS

8LOOSENING A WHEEL NUT1. Remove any wheel trim, before selecting the appropriate socket andplacing firmly on the square drive of the wrench.2. With th

92. If no line lubricator is used, ensure that oil is applied to the tool on a dailybasis through the air inlet connection.3. For lubricating the air