Clarke Super E Edger Návod k obsluze stáhnout pdf (Strana 6)

ENGLISH

-6-

Clarke

American Sanders

Operator's Manual (EN) - Super E

12 grit For removing gross imperfections and

16 grit restore evenness to old flooring. To remove

20 grit build-up of paints and varnishes.

24 grit

30 grit For first sanding of new flooring (maple, oak).

36 grit For removing minor imperfections and finishes

from old flooring.

40 grit For initial cut on new flooring (oak, walnut).

For removing minor imperfections and finishes

from old flooring.

50 grit For first sanding of new flooring (cedar, pine,

fir) For clean-up of 16 grit.

60 grit For clean-up from initial cut 36 grit.

80 grit For final sanding of certain hardwoods. For

clean-up of initial cuts (50 grit).

100 grit For final sanding of certain hardwoods and

conifers where a smooth surface is desired.

120 grit For final sanding of certain conifers.

150 grit For final sanding of certain conifers where a

smooth surface is desired for surface

roughening between coats of finish.

SANDING CUTS AND SANDPAPER

Initial Cut

The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. A coarse

abrasive should be used.

If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this

should occur during an initial cut, the abrasive has dulled and must be replaced.

Final Cuts

The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60 - 80

grit) grain abrasive.

If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive

(80 - 100 grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close

the pores on a wood floor making admission of a stain difficult.

Grain Use

Standard Grade

Part #/Qty

Professional Grade

Part #/Qty

Standard Grade

Part #/Qty

Professional Grade

Part #/Qty

7" Diameter 7" Diameter 5" Diameter 5" Diameter

945314/50

945315/50

945316/50

94319/100

94321/100

945322/100

945323/100

945324/100

945701/250

945702/250

945703/250

945704/500

945705/500

945706/500

945707/500

945708/500

945709/500

945710/500

945594/200

945595/200

945596/200

945597/300

945598/300

945599/300

945600/300

945601/300

945602/300

945603/300

945604/300

945605/500

945606/300

945300/50

945301/50

945302/50

945305/100

945307/100

945308/100

945309/100

945310/100

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Komentáře k této Příručce

Žádné komentáře

Clarke Super E Edger Návod k obsluze Strana 6

Komentáře k této Příručce

Související produkty a manuály pro Elektrické nářadí Clarke Super E Edger