Clarke CMS10S Specifikace Strana 1

© 02/08Part Number 6501305Operating & MaintenanceInstructions10” COMPOUND MITRE SAW10” COMPOUND MITRE SAWModel CMS10

ASSEMBLY and INSTALLATION.The saw is fully assembled and adjusted at the factory. On receipt inspect themachine to ensure that all parts are accounted

11Fig.4NOTE: If the workpiece is not entirely straight, ensure that the portion at either sideof the intended cut rests firmly against the table and b

C. Straight Bevel CuttingAs with Mitre Cutting, this is a cross cutting operation, except that the blade is notperpendicular to the table, (see fig.

MAINTENANCE 1. GeneralThe machine is maintenance free, except for changing the saw blade whennecessary, maintaining adjustments, and ensuring that aft

144. Allow the blade guard to fully reassert,as shown in Fig.10, then unscrew andremove the second cover screw, asshown.This will allow the complete b

15 3. Carbon Brushes ReplacementA spare pair of carbon brushes are supplied with the machine. Should it becomenecessary to change these, evidenced by

PARTS DIAGRAM16

No. Description Part No.PARTS LISTNo. Description Part No.17 1 Circlip For Shaft 1 GRCMS1001 2 Pressure Rod 1 GRCMS1002 3 Screw M4×55 2 GRCMS1003

18

19

2For Parts & Servicing, please contact your nearest dealer, orCLARKE International, on one of the following numbers.PARTS & SERVICE TEL: 020

Thank you for purchasing this CLARKE 10 inch Compound Mitre Saw whichis designed for DIY/hobby and medium trade use only.Before operating the Mitre Sa

SAFETY PRECAUTIONSGENERAL SAFETY RULES FOR OPERATING MACHINERYWARNING:As with all machinery, there are certain hazards involved with theiroperation a

11. REMOVE ADJUSTING KEYS AND WRENCHES. Form the habit of checkingto see that keys and adjusting wrenches are removed from themachine before switching

ADDITIONAL SAFETY INSTRUCTIONSfor MITRE SAWS1. Wear safety goggles as protection against flying wood chips and saw dust. Inmany cases, a full face shi

ELECTRICAL CONNECTIONSConnect the mains lead to a standard, 230 Volt (50Hz) electrical supplythrough an approved 13 amp BS 1363 plug, or a suitably fu

PRINCIPAL PARTS OF THE SAW8Fig.1Fig.2

FEATURESAs its’ name implies, the machine is a Bevel/Mitre Saw, capable of straight crosscutting, and cutting bevels and mitres, or a combination of t