Clarke CMS10S2 Provozní pokyny Strana 20

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 28
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 19
20
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CHECKING AND ADJUSTING THE BEVEL SETTINGS
1. Loosen the bevel clamp handle.
2. Press the saw head to the right to
ensure it is fully vertical and
tighten the bevel clamp handle.
3. Pull down the head until the
blade just enters the kerf plate.
90 DEGREE STOP ADJUSTMENT
4. Place a set square on the table
and up against the blade.
NOTE: Do not touch the tips of the
blade teeth with the square.
If adjustment is required, proceed as
follows:
5. Turn the 90° adjustment stop
screw in or out until the blade is at
90° to the table as shown by the
set square.
6. If the bevel pointer does not
indicate zero on the bevel scale,
loosen the screw that secures the
pointer and move the pointer as
necessary.
Zobrazit stránku 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře