Clarke BOOST 28 Návod k obsluze stáhnout pdf (Strana 20)

ENGLISH

-20- FORM NO. 71483A Clarke

Operator’s Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER

HOW TO OPERATE THE MACHINE

How To Clean A Floor

WARNING: Water solutions or cleaning materials used

with this type of machine can leave wet areas

on the ﬂ oor surfaces. These areas can cause

a dangerous condition for the operator or

other persons. Always put CAUTION signs

near the area you are cleaning.

To clean a ﬂ oor, follow this procedure:

1. Set the parking brake (if equipped with machine.)

2. Put the water and a cleaning chemical in the clean solution

tank.

3. Release the parking brake (if equipped with machine.)

4. Turn the key switch “ON”.

5. Lower the squeegee.

6. Press the one touch control button to lower the brush head as-

sembly and start vacuum motor.

7. Adjust the ﬂ ow of clean solution to the ﬂ ow desired.

8. Move the machine across the ﬂ oor in the forward direction.

9. Make a 180° turn.

NOTE: When you make more passes across the ﬂ oor, let the brush

clean approximately 2 inches (5 cm) of the area already cleaned by the

brush.

NOTE: During most cleaning procedures, apply and remove the solu-

tion in one operation.

How To Clean A Very Dirty Floor

To clean a very dirty ﬂ oor, follow this procedure:

1. Apply solution to the ﬂ oor.

2. Do not lower the squeegee. Shut vacuum motor “OFF”.

3. Lower the brush or pad and scrub the ﬂ oor.

4. Scrub the ﬂ oor again with additional solution and lower the

squeegee and turn vacuum motor “ON”.

5. Pick up all the solution with the squeegee.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 123 124

Žádné komentáře

Clarke BOOST 28 Návod k obsluze Strana 20