Clarke CWL325V Manuál s instrukcemi stáhnout pdf (Strana 9)

9

Fig 3

Fig 1

Fig 2

ASSEMBLY

1. Screw the tailstock spindle into

the tailstock as shown in Fig 1.

Note: A left-hand thread is used

for this.

2. Attach the tailstock spindle

locking lever and the tailstock

locking lever in their postions

using the coil spring and

machine screw provided.

3. Attach the tool rest locking lever

and the support locking lever in

their postions using the coil

spring and machine screw

provided for each as shown in

Fig 2.

4. Install the tool rest of your

choice into the hole in the tool

rest support. Position the

working edge of the rest parallel

with the centre axis of the lathe

and secure with the tool rest

locking lever.

The position of the support will

be adjusted to suit the

workpiece.

5. Screw the faceplate onto the headstock

spindle while inserting the drift rod into

the hole in the spindle to prevent it from

turning. Tighten the faceplate using the

open spanner provided as shown in Fig 3.

6. If the work is to be held in position

between the headstock and tailstock,

insert the headstock spur into the

tapered hole in the headstock spindle.

Provided the faceplate is fitted, the spur

can be removed later by driving it away

from the headstock by unscrewing the

faceplate with the spanner in the usual

way.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře