Clarke 00311C Návod k obsluze stáhnout pdf (Strana 22)

ENGLISH

Page -22- Form No. 71171A Clarke

Operator’s Manual (EN) - Focus Rider

How To Operate the Machine

How to Clean a Very Dirty Floor

To clean a very dirty ﬂ oor, follow this procedure:

1. Apply solution to the ﬂ oor.

2. Do not lower the squeegee. This will keep the vacuum motor off.

3. Lower the brush or pad and scrub the ﬂ oor.

4. Scrub the ﬂ oor again with additional solution and lower the squee-

gee.

5. Pick up all the solution with the squeegee.

Do These Procedures When You End Your Work Period

Having ﬁ nished the job and before any type of maintenance is done,

follow these procedures:

For one touch cleaning shut down process, press and release the one

touch button.

For manual shut down follow these procedures:

1. Turn the solution ﬂ ow off by decreasing the ﬂ ow to its minimum

position.

2. Press the brush up/down switch to the up position until the brush

head has reached its up most position.

3. Place the squeegee up/down switch in the up position to raise the

squeegee and allow the vacuum motor to continue to run. The

vacuum motor will run for another 20 seconds and then place the

squeegee up/down switch to the up position. This will shut the

vacuum motor off.

4. Take the machine to a water drain.

5. Turn the key switch “OFF”.

6. Remove the drain hose from the holding hook.

7. Put the end of the hose over a drain or bucket.

8. Turn the valve housing to the left (see ﬁ gure 34).

9. To open the valve completely, turn the housing fully to the left.

Pull the housing off of the valve.

10. Empty the recovery tank. NOTE: When hose is lowered below

water level, water will ﬂ ow.

WARNING: Use gloves to protect your hands from

contact with dangerous solutions when

preforming the steps listed above.

Figure 34

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 129 130

Žádné komentáře

Clarke 00311C Návod k obsluze Strana 22