Clarke BOOST 28 Návod k obsluze Strana 23
- Strana / 142
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
ENGLISH
Operator’s Manual - FOCUS
®
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
23
MAINTENANCE
WARNING!
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
WARNING!
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an
authorized Service Center.
WARNING!
The procedures must be performed with the machine off and the batteries disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted at
any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after
using the
machine
Weekly
Every six
months
Yearly
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank and vacuum grid with fl oat cleaning, and cover gasket check
Squeegee blade check and replacement
Solution/clean water fi lter cleaning
Vacuum system motor cleaning
WET battery fl uid level check
Screw and nut tightening check (1)
Brush/pad-holder motor carbon brush check or replacement (2)
Vacuum system motor carbon brush check or replacement (2)
Drive system motor carbon brush check or replacement (Only for
FOCUS II L17, FOCUS II L20, FOCUS II L20 Cyl., BOOST L20)
(2)
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by Clarke authorized Service Center.
- Form No. 9097066000 - 12/2007 1
- TABLE OF CONTENTS 2
- OPERATOR SAFETY INSTRUCTIONS 3
- INTRODUCTION 5
- TECHNICAL DATA 6
- MACHINE TRANSPORT PROCEDURES 7
- SYMBOLS SHOWN ON THE MACHINE 7
- MACHINE DESCRIPTION 8
- Operator’s Manual - FOCUS 9
- Figure 2 9
- CONTROL PANEL 10
- SETTING (WET OR AGM) 12
- BEFORE START-UP 13
- Types of brushes available 14
- II L20 Cyl.) 15
- Mixing System) 17
- MACHINE START AND STOP 18
- Machine drive controls 19
- Detergent fl ow adjustment 20
- TANK EMPTYING 21
- AFTER USING THE MACHINE 22
- MACHINE LONG INACTIVITY 22
- FIRST PERIOD OF USE 22
- MAINTENANCE 23
- SQUEEGEE CLEANING 24
- BRUSH/PAD CLEANING 26
- DETERGENT TANK CLEANING 28
- DECK DISASSEMBLY/ASSEMBLY 29
- BATTERY CHARGING 30
- MACHINE WORKING HOUR CHECK 32
- FUSE CHECK/REPLACEMENT 32
- TROUBLESHOOTING 33
- INTRODUCCIÓN 37
- DATOS TÉCNICOS 38
- PROCEDIMIENTOS PARA EL 39
- TRANSPORTE 39
- SÍMBOLOS 39
- DESCRIPCIÓN DE LA MÁQUINA 40
- Figura 2 41
- PANEL DE CONTROL 42
- LA MÁQUINA NUEVA 43
- Tipos de cepillos disponibles 46
- Parada de la máquina 50
- VACIADO DE LOS DEPÓSITOS 53
- DESPUÉS DEL USO DE LA MÁQUINA 54
- PRIMER PERIODO DE UTILIZACIÓN 54
- MANTENIMIENTO 55
- LIMPIEZA DE LA BOQUILLA 56
- LA BOQUILLA 57
- DE ASPIRACIÓN 58
- DETERGENTE/AGUA LIMPIA 58
- LA GUARNICIÓN DE LA TAPA 59
- PORTACEPILLOS/PORTAFIELTROS/ 61
- PORTACEPILLOS CILÍNDRICOS 61
- CARGA DE LAS BATERÍAS 62
- BÚSQUEDA AVERÍAS 65
- FRANÇAIS 67
- CARACTERISTIQUES TECHNIQUES 70
- PROCEDURES POUR LE TRANSPORT 71
- DESCRIPTION DE LA MACHINE 72
- TABLEAU DE BORD 74
- UTILISATION 75
- Types de brosses disponibles 78
- (seulement pour 79
- Mise en marche de la machine 82
- Arrêt de la machine 82
- VIDANGE DES RESERVOIRS 85
- ENTRETIEN 87
- SYSTEME D'ASPIRATION 90
- L'EAU PROPRE 90
- PORTE-BROSSES CYLINDRIQUES 93
- CHARGEMENT DES BATTERIES 94
- DEPISTAGE DES PANNES 97
- Parts List 99
- General View 100
- Solution Tank 102
- Solution Tank - 10/07 103
- Recovery Tank 104
- Recovery Tank - 09/07 105
- Chassis System 106
- MACHINE WITHOUT DRIVE 108
- MACHINE WITH DRIVE 108
- Wheel Systems 108
- Wheel Systems - 09/07 109
- Handle Assemblies 110
- Handle Assemblies - 09/07 111
- Solution System 112
- Solution System - 12/07 113
- Squeegee System 114
- Squeegee System - 09/07 115
- FROM 1 TO 53 = 9097150000 116
- Brush System - 09/07 117
- Parts List - FOCUS 118
- Brush System - 12/07 119
- FROM 1 TO 54 = 9097149000 120
- Brush System - 10/07 121
- FROM 1 TO 59 = 909 6854 000 122
- Accessories - 10/07 125
- Accessories 126
- Control Panel System - 09/07 128
- Chemical Mixing System 134
- Wiring Diagram FOCUS II Drive 137
- LIMITED U.S. WARRANTY 142
Související produkty a manuály pro Pračka Clarke BOOST 28
Pračka Clarke 00311C Návod k obsluze
(130 stránky)
(130 stránky)
Pračka Clarke Encore Návod k obsluze
(58 stránky)
(58 stránky)
Pračka Clarke Encore L20 Návod k obsluze
(29 stránky)
(29 stránky)
Pračka Clarke Alto115V Návod k obsluze
(20 stránky)
(20 stránky)
Pračka Clarke Boost 32 Návod k obsluze
(102 stránky)
(102 stránky)
Pračka Clarke Vantage 17 Battery Návod k obsluze
(94 stránky)
(94 stránky)
Pračka Clarke Alto Vision 17E Návod k obsluze
(40 stránky)
(40 stránky)
Pračka Clarke Alto Vision 17E Uživatelský manuál
(60 stránky)
(60 stránky)
Pračka Clarke 26IX-00300A Uživatelský manuál
(62 stránky)
(62 stránky)
Pračka Clarke Alto115V Návod k obsluze
(12 stránky)
(12 stránky)
Pračka Clarke Bext-100 Návod k obsluze
(13 stránky)
(13 stránky)
Pračka Clarke Encore L33 Uživatelský manuál
(34 stránky)
Pračka Clarke Bext-150H Uživatelský manuál
(20 stránky)
(20 stránky)
Pračka Clarke 38I-00490A Uživatelský manuál
(9 stránky)
Pračka Clarke Bext-150H Návod k obsluze
(27 stránky)
(27 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.032 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce