Clarke BOOST 28 Návod k obsluze Strana 33

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 142
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 32
ENGLISH
Operators Manual - FOCUS
®
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
33
ACCESSORIES/OPTIONS FOR FOCUS II
In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine
specic use:
For further information concerning the above-mentioned optional accessories, contact an authorized Retailer.
ACCESSORIES/OPTIONS
See “Parts List” section.
AGM batteries
Brushes and cylindrical brushes of different materials
Pads of different materials
Chemical Mixing System
TROUBLESHOOTING
Trouble Possible Cause Remedy
The motors do not work; no warning light turns on.
The battery connector is disconnected. Connect the battery connector.
The batteries are completely discharged. Charge the batteries.
The machine does not move
(Only for scrubbers with drive)
The machine has been turned on by using
the ignition key and by keeping one of the
switches pressed.
Turn the ignition key to “0”, then try to start the
machine again without pressing the switches.
The 3 battery charge indicators are ashing
simultaneously.
Brush motor overload.
Use less aggressive brushes and/or avoid
working with extra pressure activated.
Foreign materials (tangled threads, etc.) which
may prevent the brush from rotating.
Clean the brush hub.
The brushes do not work, the red warning light is on. The batteries are discharged. Charge the batteries.
The recovery water vacuuming is insufcient.
The recovery water tank is full. Empty the tank.
The hose is disconnected from the squeegee. Connect.
The vacuum grid is clogged or the oat is
stuck closed.
Clean the grid or check the oat.
The squeegee is dirty or the squeegee blades
are worn or damaged.
Clean and check the squeegee.
The tank cover is not properly closed, or the
gasket is damaged, or the compensation hole
is clogged.
Close the cover correctly, or replace the
gasket or clean the compensation hole.
The recovery water tank is dirty. Clean.
The solution ow to the brushes is insufcient. The solution/clean water lter is dirty. Clean the lter.
The squeegee leaves marks on the oor.
There are debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or
torn.
Replace the blades.
The squeegee has not been adjusted with the
knob.
Adjust.
NOTE
Machine with battery charger installed, cannot operate if the charger is not on board. In case of battery charger malfunction,
contact an authorized Service Center.
For further information refer to the Service Manual, available at any Clarke Service Center.
SCRAPPING
Have the machine scrapped by a qualied scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the Law
in force:
Batteries
Brushes/pads
Plastic hoses and components
Electrical and electronic components (*)
(*) Refer to the nearest Clarke Center especially when scrapping electrical and electronic components.
1.
2.
3.
4.
Zobrazit stránku 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 141 142

Komentáře k této Příručce

Žádné komentáře